1997 Ford Explorer Consumer Discussions

Ford Explorer Maintenance and Repair

ford explorer 1997 no first gear

Written by: egyptgerry on Apr 09, 2008 01:00 AM

Hi there ,got a 97 ford explorer and it suddenly has no bottom gear,i can drive it in 2 and drive but if i start in drive nothing happens just a faint noise from the box,any ideas Guys Read More...

Re: Dashboard bulb@Grinding Noise from the Rear [hoptoad]

Written by: electricdesign on Jan 23, 2008 07:23 PM

For a 1997 Ford Explorer, a 1995 may be similar: It is a pain to do this. Lots of screws amd lots of plastic to carefully and patiently bend and remove. 1. Remove the lower plastic panel under the steering wheel, it has 2 screws from underneath on each side, and 2 screws to remove on the hood release. Once the screws are out on the bottom, grab the panel at the top corners ... Read More...

Ford Explorer Starting and Stalling Issues

Ford cold start problems

Written by: enforcer on Feb 20, 2008 02:11 PM

I have the same problem with my 1997 Explorer. It only occurs when we are doing a cold start in the morning near Lake Tahoe, i.e. when outside temp is 4000ft. The starter and alternator are fine, but it just won't turn over. Very frustrating as it is hard to replicated in the shop. Fortunately it always seems to start up after waiting 15-45 min. Could never figure out ... Read More...

Ford Explorer Maintenance and Repair

Battery And Lights

Written by: jondomke on Nov 14, 2007 10:36 PM

I need help. I own a 1997 Ford Explorer and it has been sitting idle for the past 3 or 4 months as I have not been able to use it. My battery must have completly lost its charge because I have to constantly jump start it. I will jumpstart it and then an hour later when I try to start it again, it wont start. As soon as I noticed this problem, I noticed another. My daytime running ... Read More...

Re: 1998 ford explorer [mrkevv07]

Written by: electricdesign on Nov 11, 2007 09:07 AM

You will need to troubleshoot the circuit, checking for the presence of power thoughout the circuits, to see where you are loosing the power. You will need some electrical expertise if you get into checking the wiring, and a good wiring diagram will help. I have a 1997 drawing, it shows power coming from a 30 amp maxie fuse, then it goes through a black/white wire ... Read More...

Ford Explorer Transmission Questions

Transmission Fluid Levels

Written by: dhuth on Sep 23, 2007 09:42 AM

I recently drained the transmission filter pan and installed a new transmission filter on my 1997 Ford Explorer Sport. How many quarts should I add to bring the level back to nominal operating levels? Read More...

Ford Explorer Mercury Mountaineer Real World MPG

Re: Ford Explorer/Mercury Mountaineer: MPG-Real World Numbers [steve_]

Written by: hazmat456 on May 20, 2007 05:08 PM

1997 mercury mountaineer 136,000 miles 31-10.5/15 tires a/c compressor runs no matter what you do so winter/summer dose not seem to make much difference i get 13.8 mpg average i have a 3500lbs camper and that dose not make a difference Read More...

Ford Explorer Maintenance and Repair

Re: 2000 V-8 AWD Transmission Life?? [jimja43]

Written by: electricdesign on Oct 10, 2006 09:14 PM

I have Two V8 Explorers, a 1997 with 150K miles, and a 2000 with 128K miles, both run and shift like new, I really love them both. Both Explorers are two wheel drive, not AWD. They are the best automatic transmissions that Ford puts in the Explorers. Like anything else, they do have some minor inheirent weaknesses, but overall they are very strong and reliable. I ... Read More...

Re: Explorer Transmission Problems [doug66]

Written by: electricdesign on Sep 28, 2006 09:46 AM

I have said this over and over again, but here goes one more time. The FORD EXPLORERS with the SOHC V6 have problematic engines and problematic automatic transmissions. The model year 2002 and up have problematic rear axles due to the new full floating design and the aluminum rear axle gearbox housing. If you do your research and homework, you will find this to ... Read More...

emarens

Written by: emarens on Aug 27, 2006 08:59 AM

I have a 1997 Ford Explorer with 169,000. The front end has been sqeaking for some time now and several repair shops tell me I need upper and lower ball joints. I have had my uppers replaced under warranty through JD Byrider in June of 2004. Is it possible for them to already be worn? Read More...