1993 Mazda 626 Consumer Discussions

1993 mazda 626 shifting problem

1993 mazda 626 shifting problem

Written by: tscruggs on Nov 01, 2009 10:08 AM

I have a 1993 mazda 626 and I am having a problem with it shifting. When driving the car it shifts hard into the gears and the "hold" light flashes on the dash. It will not go into overdrive. This is the 3rd transmission in the car and it is doing the same exact thing!! The transmission that is in the car now only has 50K miles on it!! This has to be an wiring or electrical ... Read More...

Mazda 626 Transmission Questions

Turn signal slow to start

Written by: ronper on Jun 01, 2009 08:16 PM

I have a Mazda 626 1993 model 4cyl Auto transmission car. Since of late, when I want to indicate to turn left or right, it takes a few minutes before it starts to flash. On hot days it flashes OK. I also find that when the hazard warning is switched on, the indicatoir lights flash normally. Any ideas about this problem? Read More...

Mazda 626 Electrical Issues

Starting problem

Written by: jturner94 on Apr 30, 2009 07:32 PM

I have a 1993 Mazda 626 4 cyl it would start sometimes first try and then sometimes second try and sometimes I had to wait a few minutes and try again, It also cut off a few times while driving and I had to do same . the problem I had to replace the whole distributor it cost a little more than 200.00 but everything works fine now Read More...

Mazda 626 Troubles

Re: 1993 Mazda 626 cv joint problem [peterp96a]

Written by: edagger3274 on May 11, 2007 01:01 PM

..........and thats what it took. i got that sucka off. i just beat on it until fiunally it gave. the passenger side was a whole lot easier. it rides so much better now. thanks for the help. Read More...

Re: 1993 Mazda 626 cv joint problem [edagger3274]

Written by: peterp96a on May 10, 2007 08:12 PM

I had same problem before too. I took the card to shop, the mechanic just beated on it with a prybar, chain and a sledge hammer. Read More...

1993 Mazda 626 cv joint problem

Written by: edagger3274 on May 09, 2007 00:37 PM

hi. came back once again with a problem. im working on my mazda 626 and im replacing the cv joints. im stuck on the driver's side right now because i cant seem to get the cv joint out of the transmission. the new one just has a metal ring around the shaft that goes into the transmission. is there any special tool i need or do i just keep beating on it with a prybar and a sledge ... Read More...

Mazda 626 Security System

Mazda 626 Alarm Will Not Turn Off

Written by: jwestbrooks on Feb 20, 2007 10:05 AM

1993 Mazda 626 LS factory alarm, once activated, sounds when unlocking driver door w/key. I have to open trunk or passenger side to reset. Any experience/ideas on this one? Can it be disabled? Read More...

Mazda 626 Troubles

Re: 2000 626 4CLY CODES [carguy32]

Written by: mazda626atx on Jul 15, 2006 06:26 AM

I have the Haynes Manual for Mazda 1993 thru 2001 including both OBDl and OBD-ll. All the OBD ll codes start with a P and then an 0 for example PO100, PO102 etc . My Manual shows nothing resembling what you have listed Maybe you can get it read at Auto Zone for free and come back with the new code. I will be checking in every few days. Good Luck PGP :) Read More...

Mazda 626

Mazda 626 V6 Rough Idle & Acceleration Hesitation

Written by: dolby on Mar 28, 2006 08:07 AM

This posting reports back on a successful solution. The 1993 Mazda 626 with V6 & 110,000 kilometers would hesitate when trying to accelerate at highway speeds, and idle rough, only when engine was warm. It was known that oil was in the speark-plug wells, both front and rear rockers. There were no Codes to assist diagnosis. Problem solved when both gaskets replaced ... Read More...

Mazda 626 Troubles

1993 mazda 626

Written by: bugman2 on Mar 16, 2006 09:57 PM

I have no fuel pressure or fuel coming out of return fuel line. I have lost of gas in tank. Pump seams not to be running. Is there a relay or bump shut-off switch in this system. Thanks Read More...