2003 Jeep Liberty Consumer Discussions

Jeep Liberty Starting and Stalling Difficulties

Re: Stalling Issues 2003 jeep liberty [jar452]

Written by: caribou1 on Nov 06, 2009 01:02 PM

I was told that the rear differential sensor cable must remain out of reach from the hand brake cables. It's one of the hand brake cables that tears the sensor wires. Read More...

Re: Stalling Issues 2003 jeep liberty

Written by: jar452 on Nov 05, 2009 10:18 AM

So, I had the same issues: my speedometer was at 0 when going about 70 and the jeep would stall when I was coming to a stop. I just got it back from my mechanic and it's all fixed. Here is the problem: there was no slack in the wire that runs out to the speed sensor at the top of the rear differential. I must've hit a bump that knocked it loose. My mechanic was able to re-route ... Read More...

Jeep Liberty Electrical and Lighting Questions

Gauges zero out when air is on.

Written by: spooks94 on Oct 28, 2009 04:37 PM

I've had my 2003 Jeep Liberty for about three years now. Shortly after I got it the speedometer would drop to zero and then return to normal. I brought it back to dealership twice and both times they told me nothing was wrong with it. Now the the speedometer doesn't work at all. When the air is on the doors won't lock automatically and the temp, RPM, and gas gauge all ... Read More...

Jeep Liberty Noises and Sounds

2003 Jeep Liberty 3.7L whining & slipping

Written by: fedup2003 on Oct 20, 2009 04:20 PM

I have a 2003 Liberty which I bought new. I have had so many problems with this vehicle. 2 motors, 3 transmissions (the 1st was replaced at 4000 miles) bearings, air conditioning problems nonstop......etc. A couple of weeks ago I noticed a growling noise with matching vibration, during acceleration. We checked bearings and differential then changed the fluid ... Read More...

Jeep Liberty Electrical and Lighting Questions

Re: Jeep Liberty: Electrical & Lighting Questions [Mr_Shiftright]

Written by: cane59 on Oct 15, 2009 07:58 PM

The turn signals and emergency flashers on my 2003 Liberty are not working. When I press the flasher button, it lights very dimly but does not flash. I could not find a flasher relay in the owner's manual. Any suggestions? Read More...

Jeep Liberty Starting and Stalling Difficulties

Re: Stalling Issues 2003 jeep liberty renegade [pktechgirl]

Written by: jrlopez14 on Oct 12, 2009 01:51 PM

i had similar problems too but mine wasnt with turns or stops but the codes did tell us that it was the camshaft and crankshaft sensor and we bought then and we did it ourselves its really easy...when we took our sensors off the were rusted on. Read More...

Re: Stalling Issues 2003 jeep liberty renegade [pktechgirl]

Written by: mfitzyk on Oct 12, 2009 06:51 AM

A $7 can of throttle body cleaner ought to do it. The Jeep diverts exhaust back through the intake to decrease emissions which clogs up the throttle body with carbon deposits and decreases air flow. Your Jeep probably only stalls @ stop signs and red lights or while slowing down and not on the freeway because it is getting enough air plus has the forward momentum ... Read More...

Re: Stalling Issues 2003 jeep liberty renegade [xbeanx]

Written by: pktechgirl on Oct 11, 2009 11:02 PM

My 2005 Liberty Renegade (manual trans) just started having the same stall/idle issue, same symptoms over the last few days. It's got 61k miles. Day before I'd just finished a 600 mile drive and was using the defrost. I'd left the defrost on when I got out and thought maybe it wore out the battery. Swapped battery and jeep restarted but stalled over and over, especially ... Read More...

Jeep Liberty Electrical and Lighting Questions

Re: Body Control Module vs Low Beam Relay 2005 Jeep Liberty [wezwe]

Written by: libertygirl13 on Oct 08, 2009 04:15 AM

For the first time, my outside lights flickered up and down (looked liked I had flickered the highbeams on) on their own...It happened a few times and my hand wasn't near the highbeam lever...hummm I own a 2003 Jeep Liberty ( 138,000 miles) I hope that this isn't a major problem...Does anyone know how to fix this if it becomes more serious? Read More...

Jeep Liberty Starting and Stalling Difficulties

Re: Stalling Issues 2003 jeep liberty renegade [xbeanx]

Written by: xbeanx on Sep 28, 2009 06:18 PM

Ok update. Got home from work went to where my Jeep was at. Turns out the code was flashing "misfire on cylinder 3" so i swapped the coil of cyl3 with the one on cyl1. I reset the code and let it idle.. sure enough after 5 mins of idle, it registered "misfire on cyl1" So i took one of my old original ignition coils (the onlyone that was in decent condition) and placed it in ... Read More...