Select a different vehicle  
Recently Viewed
There are no recently viewed vehicles to display

Average Consumer Rating 83 Total Reviews
Write a review

Performance
Comfort
Value
Fun-to-Drive
Interior Design
Exterior Design
Build Quality
Reliability
Almost a Lemon
By LastFord on
Vehicle
2010 Ford Focus SEL 4dr Sedan (2.0L 4cyl 5M)
Review
Purchased a new 2010 Ford focus SEL sedan. Liked the exterior styling. Interior design pretty cool except for impractical cup holder location. Drove the car 13K miles when the "Wrench" light came on and lost power control to accelerator. This happened 3 times with Ford not able to do anything because "Engine" had not come on and no DTC codes where there to read. Set out on vacation only to have it happen again, this time Eng light did come on. Took to dealer. They said they knew all along it was the Throttle Position Sensor but could not do anything until code verified this. Also found out that the parts have been on back order for several weeks. Ford still has not issued a service bulletin?
Favorite Features
Ride feels stable at all speed ranges.
Suggested Improvements
Lack of throttle response should be addressed. Cup holders made for those with short arms. Would like to have tilt steering wheel option.
Recommend (0) (0)
Report it
Comments (2) Post a Comment
By chararoberson
on 08/07/11 23:32 PM (PDT)

Exact same thing happened to my 2010 SEL sedan @ 18229 miles. On a freeway diving the car jerked forward and immediately slowed. I was not able to go over 50mph. I had to take surface streets home. The throttle needed to be replaced. The dealership was helpful....it was covered under warranty but very scary and inconvenient. One shouldn't have to deal w/such a mechanical failure in car that's just over one year old.

Report it
By wingerrr
on 06/14/14 13:32 PM (PDT)

There were no trouble codes stored even though the check engine light came on? Unusual, I'd expect it should have been stored in there until cleared by someone with a scan tool. I got a code for the transmission range sensor, I think because the gear shift selector may have been in some mid position while driving, so it got confused. I cleared it with my scan tool and it hasn't recurred.

Report it
Post a Comment

You must be signed in to post a comment.

Register

ADVERTISEMENT
Nearby Inventory Zip Code UPDATE
 
ADVERTISEMENT
ADVERTISEMENT
Have a question? We're here to help!
Chat*
Chat online with us
Email
Email us at help@edmunds.com
*Available daily 8AM-5PM Pacific
Phone*
Call us at 855-782-4711
SMS*
Text us at ED411