i have a 1999 chevy s-10 with a 2.2. When i have the car running and no lights on, the day time running lights do not come on. When i turn the lights on no head lights come on. Just the running lights. If i play with the column and put it in drive i can get the running lights on. Anyone have any suggestions???
1999 s-10 2.2 truck with a miss in cylinder number 2
Written by: bingham1 on Oct 20, 2011 5:10:34 PM
i have a 1999 chevrolet s-10 2.2 pickup i have a miss in it i had it scannned it said it was cylinder number 2 i replaced plugs and wires with no change when it is cold it runs ok the more i drive the worse it gets
when i start my 1999 chevy S-10 pick up with V6 4wd the engine shakes for a few secionds and sounds like all the lifters lost there oil it gets quite after i min or two but when i step on the gas i hear them chattering oil psi is 40, oil is full with 5 - 30 just changed the oil again no change. if posable to e mail me ... Read More
I HAVE A CHEVY S10 1999 4.3 V6 WITH STARTING ISSUES (ELECTRICAL) . IT WOULD RUN FINE THEN WHEN I WOULD LEAVE PARKED FOR MORE THAN A DAY IT WOULD CRANK BUT NOT START, I WOULD KILL THE BATTERY TRYING TO START IT . I WOULD THEN RECHARGE BATTERY AND THE DARN THING WOULD START WITH NO PROBLEM , THE PROBLEM PERSISTED I BEGAN TESTING THINGS AND REPLACING PARTS COIL,IGNITION MODULE, ... Read More
1999 Chevy S10 2wd 2.2L I'm not an expert so I appreciate any advice with this: - Recently bought the truck from someone who'd let it sit for 1+ years so I don't have all of the details, hopefully enough though. - Apparently he developed a ball-joint problem and let it go too long. Here's the result: (B) = ball joint ripped out of the upper control arm. (C) = can't ... Read More
I am no expert, but I am sure you cant. I think front wheel drive motors turn oppisite direction than a rear wheel drive motor. Also just for info, look up 3.4 camaro engine swap. Hope this helps.
1999 Chevy S10 engine swap
Written by: fran4066 on Feb 15, 2009 2:33:21 PM
Does any one know if one can swap a 4.5 V6 from a 2005 Malibu into a 1999 Chevy S10 with a 4.3 V6, what would be the changes that need to be made, if any. Thank you for your help
Hi - try this ... Or search on the net for somehting similar. If the Sensors get dirty - or if the got moved during the Ball joint change - it will trigger the ABS ... this is part of a service notification - it may not be exactly what you have - but you can get the drift of the issue ... ============== Brakes - Low Speed (Below 5 MPH) ... Read More
Erase the code and don't go far to get it checked, it most likely will not set a code. Some day the transmission will over heat and damage the converter and clutches.
it has about 110,000. now that i failed inspection because of it, do i need to rebuild trans? do you think there is anything i can do to get it to pass?
It is for worn out parts in the transmission, yours has to be high mileage.
1999 chevy s-10 pickup 2.2 engine - code p1870???
Written by: tony2x43 on Jul 23, 2008 9:30:48 AM
i went to motor vehicle for inspection and they told me i have code p1870 coming up on obd II. is this a transmission code? if so i am not noticing any thing wrong with trans. what is the cause of this code?
Written by: pfallone001 on Jan 12, 2008 9:46:40 AM
Sounds like a cap/rotor failure or fuel pressure issue. Remove the dist. cap and check for watermarks, wear, or carbon tracking. Replace them if you see a problem. also if your fuel filter has not been changed it would be a good idea, being significantly less than a fuel pump. Bosch and Autolite SUCK in GM ignition systems, so replace with ACDelco unless you like changing parts often. You really get ... Read More
Chevy S-10 1999 4.3L P0300 Code
Written by: djcrzysounds on Jan 7, 2008 7:20:40 PM
Ok so this morning I was on my way to work NO PROBLEMS... stopped for gas(shut the truck off)... filled the tank... went to start the truck.. and thats when the problem started... check engine light... (flashing random pattern) and rough idle as well as running.. went to Advanced auto after work and had them read the computer P0300 code (Multi-Cylinder Misfire) so picked up plugs and wires... (Bosch Platinum 2s ... Read More
1999 Chevy S-10 PU 4.3 ltr. engine, won't start when wet, once it dries out and the weather clears it will start. We've replaced cap, rotor, plugs, fuel pump and fuel injectors. Check engine code of P0300 (random misfire). Can anyone help this is getting very frustrating!
S-10 starting problem
Written by: jrod332 on Oct 11, 2007 1:35:25 PM
I Have a 1999 Chevy S10 4.3 Vortec. I am having a problem starting the truck when it sits for a while. It will crank over for several minutes. Once it starts and i run it, it will start all day with no issues. It only happens when it sits over night. The fuel pump turns on and has been replaced. The plugs, wires, and cap all have been done. Tried ... Read More
I own a 1999 S10 and it rattles very loudly at idle and below 10mph. I found the catalytic converter to be the cause. More specifically, the internals of the converter were "rattling" around inside of it causing the noise.
Re: 1999 Chevy S10 Pickup Rattling [21b2]
Written by: canufixit on Mar 14, 2007 10:03:06 AM
If the rattle sounds like it's in the top out side corners of the dash - it might be the hood hinges rattling - these is a TSB on this at least for 2K - 2K2 years .. They add a spring washer in the hinge ..
1999 Chevy S10 Pickup Rattling
Written by: 21b2 on Feb 28, 2007 3:29:13 AM
Year, make and model - (99 Chevy S10) Engine size (V.6) Manual or automatic transmission (Auto trans) Mileage (115240) (2WD) The truck runs great except between about 45mph-60mph. At that point there is a rattling that sounds like its coming from the dash, and below the floor (feels kinda like your in the run gear in a manual). But outside that mph range,Any Ideas? (Ride quality issue, more then a driveability ... Read More
1999 chevy s10 2.2l Can a loose connection (busted housing) affect trucks ability to start/Affect the electrical systems overall. MY S10 has died and doesn't seem to hold a charge.
I have a 1999 Chevy S-10 pickup. In the past three months it has started having problems with the engine catching while cranking from a cold start. The problem has continued to grow worse as time goes on. I can hear the engine cranking and am able to get the engine to start every time, but it takes longer and longer each time to get it to catch. Once the engine ... Read More
Re: 4WD Failure [canufixit]
Written by: skyethor on Jul 17, 2006 5:14:07 PM
yep i agree most american cars i have had were waiting to fall apart. My wife had a 1999 Ford Taurus. Replaced the transmission, then the main bearing seal needed replacing, then the wipers would turn on by themselves when you made a left turn. Of course all thsi occures after the warranty ended. Well The dealer on my Chevy said the dash had to be taken out to get to ... Read More
1999 S10 problems after some time of running ...
Written by: tjdude on Sep 5, 2005 3:34:27 PM
I just bought a 1999 Chevy S10 pick up, 5 speed 2.2L. Everything seems ok but the only problem is that after running for a while, when i make a stop, and try to shift to 1st, the engine will stop or it will start jumping like when you take out the clutch out and don't put enough gas on the engine, then if i put it in to neutral, at ... Read More
Re: Need help code P0410 [tlseipel]
Written by: alcan on Aug 15, 2005 4:58:25 AM
Here's the TSB relating to your P0410 trouble code: 2001 Chevy Truck S10/T10 P/U 4WD V6-4.3L VIN W Emissions - MIL Lamp ON/DTC P0410 Set Bulletin No.: 04-06-04-015 Date: March 22, 2004 TECHNICAL Subject: Check Engine Light On, DTC P0410 Set (Replace AIR Pump, Install New Hose Assembly) Models: 1999-2003 Chevrolet Blazer, S10 1999-2001 GMC Jimmy 1999-2003 GMC Sonoma 1999-2001 Oldsmobile Bravada with 2.2L or 4.3L Engine (VINs 4, H, 5, ... Read More
Re: 1999 Chevy S10 Problems [tfazzio]
Written by: rforty on Aug 11, 2005 5:56:28 PM
Same year S-10, same problem on the Converter and the recline handle. Just happened. A friend told me to change the converter myself. Just bolts on. I also have a driver side door leak probably due to a warped hinge. I;m just glad the thing runs O.K. My Sympathies, Randy
Re: Transmission Problems [ump50]
Written by: shaz5 on Jul 7, 2005 9:28:11 AM
hey, i have a 1999 s10 and i have the same problem. after driving an hour plus, the transmission will not shift into the high gear. if i let it cool for about 20 minutes, it is okay again. it also sometimes seems to be slipping or searching for gears when i am driving over 60 miles an hour. it definitely does seem to related to the operating temperature, i.e., once ... Read More
Written by: fbaysinger on Jun 27, 2005 12:58:49 PM
I have a similar problem with a 1999 Chevrolet Astro, misses on idle, when hot, sounds like a snap (similar to spark gap), but no visible breaks in insulation, I have 75K on engine, appears to be no power loss, just the miss at Idle. Sure hope someone can find the solution to your problem as I am sure that is partly my problem..... Good Luck - Mr Goodwrench where are ... Read More
Hi, Maybe this can help ??? Fuel System - MIL ON/Rough Idle on Start-Up File In Section: 06 - Engine/Propulsion System Bulletin No.: 00-06-04-003B Date: February, 2003 TECHNICAL Subject: Rough Idle After Start, And/Or A Service Engine Soon (SES) Light (Unstick And Clean Central Sequential Fuel Injection (CSFI) Poppet Valves or Convert to MFI) Models: 1995-2002 Chevrolet and GMC S/T Models 1996-2002 Chevrolet and GMC C/K, M/L, G, P Models 1996-2001 ... Read More
no title
Written by: alcan on Dec 12, 2004 7:56:26 PM
Document ID# 390324 1999 Chevrolet/Geo S10 Pickup - 2WD Support Cable Replacement - Endgate (Pickup) Removal Procedure Safely support the endgate in the open position. Remove the bolts that retain the endgate supports to the endgate. Remove the endgate supports from the vehicle. Installation Procedure Install the endgate supports to the vehicle. Install the bolts that retain the endgate supports to the vehicle. Tighten the bolts to 2.8 N·m ... Read More
1999 Chevy S10 Problems
Written by: tfazzio on Jun 22, 2001 1:24:12 PM
I've had a couple problems with my 99 S10. First, the third door began squeaking constantly. I took it to the dealer and the interior panel had come loose so they popped it back on. It happens from time to time but it's easy to fix on your own. Second, I always here a rattling sound from exhaust system. I took it to the dealer. Dealer replaced catalytic convertor (about 30,000 ... Read More
For some reason the Splashes haven't held their value initially. Maybe the Edge model will do better. But it is a stylish truck no doubt about it. I seem to remember the 5-speed automatic coming around maybe in 1999 or 2000, don't think the 98's had them. I agree that a ranger or S-10 can get "lost" among the behemoths, but parking one is definitely a lot easier. My LB F-150 ... Read More
'98 and '99 2.2L engines-letter from GM
Written by: derekshawn on May 23, 2000 4:22:56 AM
I just received a letter from GM concerning the 2.2L engines in the 98 and 99 S-10 trucks. I used to own a 98 S-10 but traded it a few months ago because I was experiencing numerous problems, among them was this one: the letter reads: "This letter is intended to make you aware that some 1998 and 1999 model year S10 trucks, equipped with a 2.2L 4-cylinder engine, may experience ... Read More
SCHLEUSS
Written by: schleuss on Apr 14, 2000 9:45:51 PM
Can someone please help explain a passenger side ticking noise in the engine of my 4.3L S-10 4x4(1999 year with 14k miles). Dealer replaced rockers and push rods on that side.Was quiet for a couple 100 miles and is starting to get louder again.Dealer said there was no noticable ware or damage to parts they replaced. Took truck back to dealer, they basically said if it goes under warrranty then they'll ... Read More
1999 s-10
Written by: blearman on Mar 11, 2000 10:15:30 PM
martyg2: #103...... I also have a '99 s-10 with the same noises in the transmission. my dealers also say that they are the normal noises. i guess we both are hearing little gremlins that chevy wants nothing to do with. I have 15,000 miles on mine and have had to change the pinion bearing seal 3 times. has anyone had this problem. also, two nights ago i had both of my ... Read More
Used cars move off the lots fast. Edmunds partners with specific dealers who are committed to making sure you
can inquire about the car you're interested in quickly and easily, by providing us their e-mail address and signing up for our Edmunds Direct program.
Favorite Searches (0)
Favorite Searches (0)
Close
Name Your Search:
Tip:Add any search you've done to your favorites and come back later to easily recreate them. You can even name your searches so they're easy to remember.
