Custom Sedan (2.5L 4-cyl. 3-speed Automatic)
|Ratings Key||Minimal Problems||Moderate Problems||Significant Problems|
Common problems on this vehicle are failures of the Fuel Injectors, the Electronic Control Module (ECM) and the Mass Air Flow (MAF) Sensor. These failures apply to the 3.3L V6 MFI engine only. Failure of the ECM or the Fuel Injectors may prevent the vehicle from starting.
The cost to repair the Fuel Injectors is estimated at $126.00 each for parts (total of 6) and $123.50 for labor.The cost to repair the ECM is estimated at $134.00 for parts and $91.00 for labor.The cost to clean the MAF Sensor is estimated at $32.50 for labor.All prices are estimates based on $65 per flat rate hour and do not include diagnostic time or any applicable sales tax.
|Transmission & Driveline|
|Steering & Suspension|
|Heating & Air Conditioning||
This vehicle was originally charged with R-12 refrigerant which is no longer being manufactured.
The refrigerant is still available, but it is very expensive ($25.00-$50.00 per pound, 2-5 pounds per vehicle). Conversion to the new R-134A refrigerant is possible, at an average cost of about $100-$250 parts and labor. All prices are estimates based on $65.00 per flat rate hour and do not include diagnostic time or any applicable sales tax.
|Starting & Charging|
|Overall||4 out of 5|